Small, lingt and roubst
The Micro III is an extremely small instrument cmpared to other detectors. Micro III weigh just 61g & can comfortably fit into a shirt pocket. A built-in clip secures the MICRO III safety to a belt or pocket. The casing is extremely shock and scratch resistant. The protection type IP 56 indicates that the instrucment is sealed against dust and water. The MICRO III use the AQUA-SHIELD (accessory sencor inlet) which ensure that the monitor will provide excellent performance in harsh conditions.

More protection through easier operation
The G201 and the G202 is produced without buttons or switches. Therefore an operating error is completely eliminated.

Plug-in smart sensor
The plug-in smart sensor can be easily replaced. The MICRO III recognizes the new sensor type another measuring gas, detection range, calibration curve, as well as alarm threshold values

Numerous features
The MICRO III comes standard with many features including automatic zeroing, auto calibration, confidence beep, battery check, and three factory set alarm points.

The following models are available:
G201 with loud alarm horn and bright alarm lamp.
G 202/G 212 as G 201, additional; display for gas concentration, battery capasity and services control.
G 203/G 213 as G 202, additional peak / minimum calibration, TWA/STEL, controlkeys for display light and service functions

Loud audible alarm
The audible alarm of the MICRO III has changing frequency. Machinery noises do not interfere with the horn signal.
The flushing LED's indicate gas alarm. The LED's are visible ast 360^o. The three alarm level and the battery alarm are clearly distinguishable

Up to 9 months operations
One single AA battery powers permanent operation. The battery can be replaced easily. once the battery has been changed, the MICRO III is ready for another 9 months after a short warm-up time.



The MICRO IV docking station
is trendsetting device managment system, which enormosly reduces cost of ownership and duration of the calibration. The docking station checks the acoustic and optical alarm functions, device errors, alarm thresholds and response times of the MICRO IV. The bump-test comprises:

• Response time - Alarm thresholds
• Alarms (optical and acoustic) - Device errors
• Device and software identification - Device errors

Up to 6 MICRO IV can be checked for utilizability (bump-test) and be calibrated simultanesouly